1. Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

How to safely remove original hand grips

Discussion in 'XJ Technical Chat' started by RusteeGold, Jun 11, 2019.

  1. RusteeGold

    RusteeGold Active Member

    Messages:
    144
    Likes Received:
    30
    Trophy Points:
    28
    Location:
    Southern California (RSM)
    I have a Seca 750 parts bike that i want to remove the hand grips because they are EOM. Can I remove them without damage? I want to install these on another bike.

    rustee
     
    RusteeGold, Jun 11, 2019
    #1
  2. dkavanagh

    dkavanagh Well-Known Member Premium Member

    Messages:
    1,302
    Likes Received:
    570
    Trophy Points:
    113
    Location:
    Rochester, NY
    I've had good luck using rubbing alcohol. Sounds weird but if you can get some rubbing alcohol under the edge of the grip and work it around, it should start sliding a bit more and maybe you can get some more in there and work it loose further back.
    I've also used it to get new grips on. It will let them slide on more easily, then evaporates.
     
    dkavanagh, Jun 11, 2019
    #2
    k-moe likes this.
  3. k-moe

    k-moe Pie, Bacon, Bourbon. Moderator Premium Member

    Messages:
    19,613
    Likes Received:
    6,706
    Trophy Points:
    113
    Location:
    The City of Seven Hills
    +1
    Rubbing alcohol, and shop air to blow the grips off.
     
    k-moe, Jun 11, 2019
    #3
    Toomanybikes likes this.
  4. dkavanagh

    dkavanagh Well-Known Member Premium Member

    Messages:
    1,302
    Likes Received:
    570
    Trophy Points:
    113
    Location:
    Rochester, NY
    It's funny, but that's probably the 2nd tip I've posted that I think came from you 3 years ago when I was getting into my bike!
     
    dkavanagh, Jun 11, 2019
    #4
  5. Simmy

    Simmy Well-Known Member

    Messages:
    2,265
    Likes Received:
    1,130
    Trophy Points:
    113
    Location:
    Waterloo Ontario Canada
    You only need to remove the left as the throttle side can be transferred over with the plastic part.
     
    Simmy, Jun 11, 2019
    #5
    k-moe likes this.
  6. k-moe

    k-moe Pie, Bacon, Bourbon. Moderator Premium Member

    Messages:
    19,613
    Likes Received:
    6,706
    Trophy Points:
    113
    Location:
    The City of Seven Hills
    Also, the throttle side is mainly held in place by plastic "fingers" on the outboard end of the throttle tube. Getting that one off undamaged can be a bit frustrating.
     
    k-moe, Jun 11, 2019
    #6

Share This Page