yes thats a full kit with wires and caps . you can buy the 39.95 ones you will need 2 but will need wires and you should all ready have the caps
ohm out the pickup coils from connector at tci
did you change the spark plug caps too?
could be as simple as bad caps or corroded end of...
600 fuel tee and it has orings , Len sells those too.
fine them here at cycle recycle
ste is second from last listing
i have aYamaha 650/750 police factory service manual.
the honda is a direct bolt on fit.
the dyna coil reqiures a kit to install sold be www.xj4ever.com
must be carful of the dynatek get the real...
if it was painted correctly this should be on the side of the tank. I do like the headlight with speedo installed
ihe brakesystem rebuild spec from Yamaha is Every 4 years. MC, Calipers, Brake lines. the SS lines last longer that 4 years.
you should do this...
Yes the price that they sell for in the United States is much cheaper than I've seen around the world.
5K RPM is where the power band starts to come alive.
that will lift the slide what you are doing is "inflating " the diaphram from the underside.
that portal is to feed air to the airjets
thats not what lifts the slides, the tiny hole in the bottom of the slide make it rise.
air sucked out of the little hole creates a vacuum it the...
get a cheap soldering iron and learn to solder at minimum up grade those fuse holders to blade style inlines.
you will need 1 rated at 30 amps...
yup click the box then hit the leave conversation button.
you can also check select all and clean every thing out.
there is an option for the...
would also like to know if this is a normal xj petcock you can see a plug in it on the nipple. I do not see this style in the rebuild how to...
e stop switch shuts down emergancy stop engine relay
Emergency Stop Switch:
This switch is sometimes referred to as a "Ballast Switch" in the...
I will check my turbo manual again but going from your diagram
battery voltage goes to key from main fuse , when key is on to ignition fuse
rotate the t mark to pointer at the 3:00 position
remove cam chain tensioner this should give you enough slack to move links. if not you will...
CCW the way the wheel and motor turns when running and rolling.
clockwise you are fighting against the cam chain tensioner
oil light is low oil situation
never ignore oil light bad things happen.
the light comes on when starter button is pressed to test bulb.
sounds like they are xj700n carbs got a photo.
the lower fittings on carbs 1 or 2 at most are fuel.
the higher fittings are overflow
looks like My 83 750 maxim so the seca hatachi carbs should be ok. there should only be a single fuel hose and single vacuum hose
it is the bike...
spark plugs in or out? fighting compresion if in.
T(DC) is for the outer 2 cylinders it could be the lobes of cam on inner 2 cylinders making...
you should also be getting 12 volts along the ignition paths
4 not start or not turn over?
5 + low voltage situation feed wire red/white should be 12 volts what do you get with just key on...
all about relays and what they do
The Ultimate Relay, Switch, Sensor, and Diodes Guide
Starting/Ignition Cut-Off/Neutral Safety relay:...
kill run switch in on position? this happens more than you think.
you say"when jumping the bike at the solenoid" you mean jumping the 2 cable...
if it has the moly content, hard to tell without seeing a label.
for the tarriff years yamaha dumped the 550 and 650 to make the 600 seca II , spent millions to get the 900 approved for sale in the US and...
get a used set of 700 pistons bring to a machine shop have them do the work to the pistons.
750 pistons will not work wrist pin location is...
for 550 but shows the part
REAR WHEEL BEARING REPLACEMENT: How-To w/Pics
got any reupholsters near you? they can redo it for you.
what are your plans for your bike?
centerstand bike and you can pull on the rear tire
varify that your battery is fully charged and the voltage does not drop below 10 volts when motor is cranking.
first step to no spark is to...
this is what your bike looks like
the motor mounts on the motor have same dimentions but 1 motor has solid ant the other has rubber mounts
if your photo is your bike it is XJ750J maxim 1982. the tank is the first giveaway the second is the handel bar style for that year. the 83 has...
not canada but
big bore kits
a company out of canada sells them
next is to put the motor in it
would love to see a photo of that
Rebuilding the Yamaha Vacuum Fuel Valve w/pics
photo from above thread set to ON position see the little arrow?
it is part #3 presses on to part #2 it Keeps #2 from completly droping...
when you remove the allen socket at bottom of forks heat it up it is thred locked with yamabond or something like that makes life easier.
invert a spark plug socket on an extention
or a broom handle will work
The tool is to hold it you turn the allen screw
I let a little air out of the valve in faring and oil came out.
so what does the seperator do ?
air line rums to it from air valve to...
check clamps for proper instalation and are tight on carb to manifold boots.
could also be a leak at the manifold boots to head. both would show...