Hey I’m in need of some help. I have a 82 xj 750 maximim. The problem I am having is that under wide open throttle the bike misses out. The carbs...
after getting over the cost of the coils for my 82 XJ750 I finally purchased the kit to install on my bike. The install went great. I like the fit...
Thanks for the help wasn't sure if it was normal or not but is the brake lever usually stiff to pull?
i have a stiff front Bake lever when applying brakes. It brakes and releases fine I just have to really pull the lever to get it to apply. I have...
So I have had this bike since the beginning of the year got a good deal on it. When I first got it I took the carbs off and cleaned them out they...
so I decided the other day to check out and see how the charging system was doing and at idle the bike has 15.2 volts at the battery and off idle...
So I got the carbs all synced up they were a little off got that all fixed up idles a little better haven't been able to ride it due to the...
Thanks for the tips guys just got my carb sync tool going to sync them up and see what that does and also check the fuel tank vent. I will check...
So I have a small issue with my bike. If I say go to the gas station to get a drink and then come back out like 5 to 10 min later the bike is hard...
Xj550h, That air box that you linked looks like it's missing something to attach it to the carbs are the boots from the air box to carbs still...
i have an 82 xj750 maxim when I bought the bike it has a 2 into 1 exhaust for both sides and has pod filters and I just recetly resealed the upper...
It was at the intake boots where they meet the head used some ultra gray permatex applied a thin coating on both sides of the gasket and wiped out...
So I put rtv on the boots and that fixed the issue
If it is an intake boot would spraying brake clean around the boots change the sound or have no effect because I did that with no change
after an upper end reseal/rebuild the bike starts ok but at idle it has this loud high pitch squeal coming from around cylinder no. 4 on the...
Thanks for the info I think it would be best to replace 2 studs from rust any idea what part number would be for the inner front #3 and front...
i have an 82 xj750 maxim. I took the head and jug off to fix an oil leak. When I got it apart I notice that some head studs had a plastic cover on...
Where is a good place to pick up some fork seals dust seal and bushings for an 82 xj750 maxim
Ok thanks
i purchased the Yamaha service manual and it says use 10w30 oil. I was wanting to put in actual fork oil but not sure what weight is close. I have...