1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

loud clunk or clank while shifting??????

Discussion in 'XJ Technical Chat' started by steve71100, Oct 25, 2008.

  1. steve71100

    steve71100 Member

    Messages:
    63
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    memphis, tn
    my bike shifts fine, but it is loud while shifting. while sitting at red light and putting bike in 1st gear the bike slightly jumps forward and it is loud shifting from gear to gear. any suggestions?
     
    steve71100, Oct 25, 2008
    #1
  2. bobwinkel

    bobwinkel Member

    Messages:
    42
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    Portland Oregon area
    I would try adjusting the clutch. Sounds like its not releasing completely.
     
    bobwinkel, Oct 25, 2008
    #2
  3. stereomind

    stereomind Active Member

    Messages:
    1,440
    Likes Received:
    6
    Trophy Points:
    38
    Location:
    Tulsa, OK
    Steve, it helps to know what kind of bike you have... Some XJ's just naturally clunk when you shift.. Like the XJ1100. If the bike lurches forward quite a bit when you shift into first, it's possible that the clutch cable needs some adjustment. There's an adjustment screw on the clutch perch. Try turning it out one revolution at a time, and see if it improves. Don't go too far out, as the clutch may start slipping, and don't forget to set the lock nut.

    Also, what kind of oil are you using in the bike? Heavier oils make the clutch drag a bit, especially when it's cold.
     
    stereomind, Oct 25, 2008
    #3
  4. steve71100

    steve71100 Member

    Messages:
    63
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    memphis, tn
    sorry for not posting what bike i have....its an 86 xj700. my clutches slip slightly upon strong acceleration and i plan on replacing soon. i was just curious about the loud shifting and the lunge forward.....thanks!!!
     
    steve71100, Oct 26, 2008
    #4
  5. kd5uzz

    kd5uzz Member

    Messages:
    419
    Likes Received:
    0
    Trophy Points:
    16
    I had a similar problem. My '82 650 Maxim would also want to lurch when I revved the engine while at a stop light with the clutch pulled in. I changed my friction plates and it no longer lurches. It still clunks just a bit when I put it into first.
     
    kd5uzz, Oct 27, 2008
    #5

Share This Page