1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

How bad is this?

Discussion in 'XJ Technical Chat' started by The Dude Abides, May 19, 2017.

Tags:
  1. The Dude Abides

    The Dude Abides New Member

    Messages:
    17
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Minnesota
    20170519_162855.jpg

    I just noticed this after removing the bowl covers. Am I able to use a small amount of JB weld to "fix" this or am I screwed?
     
    The Dude Abides, May 19, 2017
    #1
  2. Jetfixer

    Jetfixer Well-Known Member

    Messages:
    3,191
    Likes Received:
    1,501
    Trophy Points:
    113
    Location:
    Nothern Indiana
    Oh boy ah you could try . Make sure it is JB weld ...not JB quick it just not the same. Another product I have used with great success is liquid steel you cut off a bit kneed it and press it in to place sets up a few minutes abd can be shaped and sanded after it sets up. You can get it at Autozone or Wallyworld . Or get another carb body .
     
    Jetfixer, May 19, 2017
    #2
  3. Toomanybikes

    Toomanybikes Well-Known Member

    Messages:
    2,836
    Likes Received:
    815
    Trophy Points:
    113
    Location:
    Tsawwassen bc
    That spot is not a machined mating suface. Only there to hold gasket from sliding out. As long as gasket is lined up when you tighten the bowl it won't matter.
     
    Toomanybikes, May 19, 2017
    #3
  4. tabaka45

    tabaka45 Well-Known Member

    Messages:
    2,400
    Likes Received:
    513
    Trophy Points:
    113
    Location:
    Brunswick, Georgia
    I agree, but I would probably try the job weld if it were mine just for looks. Be careful not to get it on the machined surface.
     
    tabaka45, May 19, 2017
    #4
  5. The Dude Abides

    The Dude Abides New Member

    Messages:
    17
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Minnesota
    Thanks a lot, I was hoping I could throw some JB Weld on it since the gasket does most of the work. That is the only spot I noticed was dinged up and really didn't want to purchase another carb because of it.
     
    The Dude Abides, May 20, 2017
    #5

Share This Page