1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

Removing alternator rotor shaft bearing from case

Discussion in 'XJ Technical Chat' started by Rasput, May 4, 2020.

  1. Rasput

    Rasput Member

    Messages:
    63
    Likes Received:
    11
    Trophy Points:
    8
    Location:
    Victory Mills NY
    1983 seca 900. Does anyone have any tips or tricks for removing the bearing that the end of the rotor shaft goes into that sits in the upper engine case? I have tried heating the area around it with a heat gun but haven't moved up to torches yet. It's still good so I don't want to wreck it. I need to get it out to clean it well and clean behind it. I'm worried that using a bearing puller on the inner race will damage it. Any advise is appreciated.
     
    Rasput, May 4, 2020
    #1
  2. Rasput

    Rasput Member

    Messages:
    63
    Likes Received:
    11
    Trophy Points:
    8
    Location:
    Victory Mills NY
    Got it. A Map Pro Torch made it fall out on its own.
     
    Rasput, May 10, 2020
    #2

Share This Page