Needle jet O-rings

I have a question on where the O-rings go when you put the needle Jets back in if the threads on the needle jet are on top and the pointy part is the bottom does the O-ring go at the bottom or the top of the needle jet does it go o'ring washer spring from the bottom up or does It Go O ring washer spring from the top down the carbs are on a 82 Seca 750

 

o-ring is the last thing to put on

 

Take needle ,install washer , install O ring all onto end of needle turn the carb upside down and install ( this keeps anything from slipping off as you install)

 

no one mentioned the spring!,
with the pointy end at the bottom, slide the spring on ,then the washer, then the "o" ring

 

Then a dab of silicone grease smeared on the assembly to keep it all together while you drop it in the carb.

 

MIXTURE SCREW, spring, washer, o-ring.

there are no washers, o-rings on the needle jet. There is a BIG spring, but that goes inside the slide after the slide/needle ass’y is installed into the carb.

 

actually the needle jet is the brass thing the needle jet needle goes into

 

Thank you for the advice

 

Also known as “the emulsion tube”