1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

First time tearing into an engine.

Discussion in 'XJ Technical Chat' started by Borinc, Nov 15, 2026 at 12:39 AM.

  1. Borinc

    Borinc New Member

    Messages:
    10
    Likes Received:
    1
    Trophy Points:
    3
    Location:
    Arkansas USA
    Are the studs all that’s holding the cylinders on the case? IMG_2140.jpeg
     
  2. Dan Gardner

    Dan Gardner Well-Known Member Premium Member

    Messages:
    1,610
    Likes Received:
    846
    Trophy Points:
    113
    Location:
    Minneapolis, MN
    Yes. Gasket can be sticky and chain guide can be a pain. Takes some patience and controlled violence- just be careful not to break anything
     
    Borinc and Timbox like this.
  3. Timbox

    Timbox Well-Known Member Premium Member

    Messages:
    2,866
    Likes Received:
    1,020
    Trophy Points:
    113
    Location:
    Wisconsin, Tomah
    I know this is a little late, but is there a reason you have opened up the engine? Just learning stuff or had an issue like compression? Take your time with it and as @Dan Gardner said Patience is the key.
     
  4. Borinc

    Borinc New Member

    Messages:
    10
    Likes Received:
    1
    Trophy Points:
    3
    Location:
    Arkansas USA
    It’s a bit of both @Timbox. I wanna learn, but my cylinders need to be rehoned and my piston rings are shot. I thought it would make a good winter project/learning experience. @Dan Gardner , I’ll be for sure taking my time with this. I wanna make sure it’s done right. I also had my head resurfaced and my valves relapped. It was pretty rough when I pulled her off. Here’s a before and after IMG_2128.jpeg IMG_2172.png
     
    Last edited: Nov 15, 2026 at 11:27 AM

Share This Page