oring in carbs

i have an 81 650 and i need to replace one of the orings under the fuel mixture screws anybody know where i can get one

 

Hey Brent, I carry the o-rings and LOTS more!:

http://www.xjbikes.com/Forums/viewtopic ... t=180.html


Idle Mixture Screw Parts:

NOTE: idle mixture screws are also referred to as "pilot mixture screws" or "pilot screws".

ddd) Aftermarket Hitachi Idle Mixture Screw O-Ring.....a "must-replace" item when rebuilding your carbs. Made of long-lasting, fuel-resistant Buna-N material.

HCP895 Aftermarket Hitachi idle mixture screw O-ring, each:
$ 1.00

HCP895SET4 Aftermarket Hitachi idle mixture screw O-rings, set of 4:
$ 3.00


eee) Aftermarket Hitachi Idle Mixture Screw o-Ring WASHER.....also a "must-replace" item when rebuilding your carbs. Made of long-lasting, fuel- and water-resistant 18-8 stainless steel material.

HCP896 Aftermarket Hitachi idle mixture screw o-ring Washer, each:
$ 1.50

HCP896SET4 Aftermarket Hitachi idle mixture screw o-ring Washers, set of 4:
$ 5.00



ims6) Aftermarket carb idle mixture screw TENSION SPRING, brand new reproductions exactly replace damaged, rusted, or missing originals. High-strength carbon-steel coil springs have a baked yellow-zinc plating as original.

HCP6573 Aftermarket reproduction idle mixture screw Tension Spring, fits all Hitachi HSC32 and HSC33 model carbs as used on all XJ650 (except Turbo), XJ700 non-X, and all XJ750 models, each:
$ 3.50

HCP6573SET4 Aftermarket reproduction idle mixture screw Tension Spring, fits all Hitachi HSC32 and HSC33 model carbs as used on all XJ650 (except Turbo), XJ700 non-X, and all XJ750 models, set of 4:
$ 10.95

 

Carb kits have the O-rings in them and are usually not to expensive got all 4 of mine for 60$ at http://www.carbkitscapital.com/. Chacal too!

 

I picked up a set of o-rings and washers for the fuel mixture screw from Chacal last week. A lot less than $60, probably under $15 for the set. If you don't need to bowl gaskets, I'd go that way.