1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

Cable and wiring routing on XJ750RJ Seca

Discussion in 'XJ Technical Chat' started by bstig60, May 29, 2008.

  1. bstig60

    bstig60 Member

    Messages:
    214
    Likes Received:
    1
    Trophy Points:
    18
    Location:
    Sharpes, Florida
    My Throttle cable and all of the wiring is routed on the left (VIN number) side of the tree. When turning the handlebars hard right, it seems the wiring is drawing very tight. Also, sometimes my engine speed increases.
    I found a routing diagram in my Haynes manual for the 650 but it isn't very clear for the 750. Does someone have the correct routing diagram for the XJ750RJ/RK.
     
    bstig60, May 29, 2008
    #1
  2. Lanmanager

    Lanmanager New Member

    Messages:
    12
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Atlanta, Ga
    Hey hey on mine the PO solved that problem by cutting the harnesses and splicing in extensions on ALL the cables - gooey electrical tape and all 8O . So I bought nearly new handlebar switches to replace all that. For the clutch, enrichment and throttle cables, I just kinda experimented until I found a good non-interference route. If I remember correctly all went under the tank bosses, b/w the coils and right b/w the center frame rails. I remember that it was not too hard to find a good path. Hope that helps.
     
    Lanmanager, May 30, 2008
    #2

Share This Page