Hi all, Im being deported. So i gotta lose the bike. I rode it all around normandy, sussex, loved it, but it began to get hard to start, I...
No the plug and pigtail came with the light. The factory supplied connection burnt, not my splice or loom. I dont care what the splices look like...
Sooo.. Had some funny problems with the ol headlight, opened up to see this: [IMG] The neg/return is burnt up. Bottom of the pic is the...
Heya, Found this: http://www.foreven.com/motorcycles/Tyres/YaSeca55.htm Thoughts?
Lil note- there are no passages in the collector, its just an empty box (Had to reweld it after patching some holes) Maybe the volume of the...
Dunno. My tool really is just an "x" with different sized bolts on each leg. This allows you to get a grip strong enough to apply enough torque,...
oh shit, that bike looks like fun
my carb boot set came with paper gaskets.. my gasket set also had carb boot paper gaskets.
Ok, sorry for long delay, been adjusting and testing. I backed off the pilot to 42.5, then 40. Each time the bogging became less of a problem,...
Yeh thats kinda what Im saying. Can we get exactly the same angle without the seat/rear fairing?
check the lines on this: [IMG]
can you take a side view of the bike as naked as possible just like the one you posted, but with the tank on? basic suggestions 1 - paint any...
Acf 50 anticorrosion spray. Amazing stuff.
Hi Tabaka, Its just not an option for me. Consider the size of the airbox hole. my engine breathes through a hole at least 10x larger. Stock jets...
This bolt might be a tad large for the following method, but: Heat the bolt, Get a socket thats just a lil too small. Hammer it onto the bolt,...
Yeh I've gone up incrementally #40 to #42.5 to #45, trying to get a yellow/orange flame in my colortune when the screws are more than 3 turns out....
heya, Ive got the tuning close, but not there yet. Its xj550 seca, breathing through stock horns into the airbox which now has had the entire...
Oh yeh, Im an AV tech/Stagehand, so the footpegs are held on by Truss pins (truss being the lattice structures you see all the lights hanging off...
Yep the kanji for "firefly" is on the clutch cover, Also, where the yics logos usually go, the katakana for "firefly" on one side and "bleeding...
[IMG] [IMG] [IMG] [IMG] [IMG] 20 months. Custom: headlight bracket, dashboard, brake caliper bracket, front fender, airbox, battery box, seat,...
RobbieRobot " Just to bring this topic to a conclusion incase anyone is searching for a solution to the same problem, I managed to figure it out...
Im not entirely sure this will fix your problem, but ebay something like this. (Worked for me)...
So.. heresy or foolishness.. But in the interests of shedding weight, what if I did away with my centrestand entirely and only ever used the...
I didn't have any so I got a pair from ebay - Honda NS125 They needed a little surgery to fit, but I'm happy with them. [IMG]
Yeh sorry, had to cut through all that nasty rubber. Heres pics of whats inside (mebbe just recreate it) the middle diode is burnt up. regarding...
My floats sit 19.8mm above gasket height at their highest point, so mebbe start there. Wet set 2mm below the lip (+/-1mm) I found that a 6mm clear...
Cheers manbot, they have stopped leaking under all circumstances. I think part of my kneejerk - straight to the forums reaction was because I've...
err vague recollections of the side stand circuit allowing the power that would usually go to the coils, to instead divert to earth. Thus - if the...
I didn't "just look at them" Float heights are perfect.
If you can remove the broken bit of tool from the pilot screw, you may still have options. Mebbe, get an impact driver (kinda like a screwdriver...
Yep its the right kit. I havent touched the petcock. Heres the worst part (are you sitting down?) So I walked away from it, had a little cry,...
Checked everything again. seats and needles are immaculate, no crud (they brand new afterall) still leaking. actually leaking out 1,3 and 4 now....
Cheers fellas, "They didnt leak yesterday when I checked the wet-set" (float height at 2mm) I've taken them apart again and adjusted the float...
4 new carb repair kits Each containing: brass needle seat needle valves needle seat o ring Pilot 0 ring Small thick round aluminium disk (fits...
I dont know. But I'm fairly certain the XJ650 is 5:1 tacho ratio. Also, fender got done, needs some tweaking but: [IMG]
I've never done anything mechanical in my life. The first vehicle I've owned by myself is the bike you guys have taught me how to build. It's not...
Check this shit: Artwork by Caleigh Illerbrun - Chichester UK. http://www.caleigh-ill.com/ [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG]
I'm looking at your rotor/stator cover and I think I'm looking at petrol stains from leaking carbs. Am I right? Cos if so, then you'll need to...
It sounds crazy. Petrol is coming out of the crankcase breather? the only way I could explain that is if your carbs are leaking petrol into the...
omg I could look at that all day. I absolutely love it.
I'm about to chop my fender (today!) Iv'e bought a nasty ratty front fender from ebay, I'll drill out the spot welds that connect the hidden fork...
This looks really nice http://motogadget.com/en/analog-gauges/analog-tacho-classic/chronoclassic/chronoclassic.html Someone else says: "60:2240 is...
Lol, no to OS rings. Yeh they had the pistons. I cant check ring gap now without tearing down the engine and splashing out on a new gasket set,...
Oh sweet jesus. I handed over the honing/measuring to a speed shop. (Weeps gently) All I remember is checking ring gap and filing them back. This...
'82 XJ550 Seca So this build has been going on for about 18 months now. I rebuilt the engine with new piston rings/refinished bores valve lap, new...
Heya, anyone know if this is still true for FZ750 Genesis carbs? If I get the carb boots can I fit these to an XJ550 seca?
Cheers Rooster, Rebuilding the starter worked wonders.. Now i gotta diagnose the lack of starting (well, it kinda woofled to life for a second or...
I ended up pulling the starter motor and testing directly with the battery. Same behaviour. It works, it works, it doesn't. does not even draw...
oops, that info used to be in my signature.. '82 XJ550 seca and yes the headlight doesn't start until the engine has fired. But the taillight and...
:( noooo It sez its 13.42V it must be ok yeh? yeh?