What about these two, do they come out? http://imgur.com/gallery/1z9aHD5
Thought that's what I did, maybe it's because I'm doing it with my phone...
Sigh... http://imgur.com/gallery/NJOfphD
[IMG]
Aftermarket Hitachi FUEL INLET - FLOAT VALVE ASSEMBLY, contains the fuel inlet - float valve needle, the brass screw-in valve seat, and the seat...
Ah that explains it. To be honest I don't think I've got any of the needles out yet, think I just undid the screws (jets?) above them. Looks like...
I'm wondering if I completely missed that, is this the tamper cap? This circle thing? http://imgur.com/gallery/hHcXBu0
Perhaps a tip cleaner for a cutting torch? Have a set on the bench here...
That's a pretty cool cross section view! Hopefully the solvent and some air will work. I'll run some carb cleaner through it too, hopefully that...
No, my cousin works at an oil distribution place and I asked him for 5 gallons of parts cleaner and that's what he delivered up, for free. Beats...
http://imgur.com/gallery/BwenFeM I bought the deluxe kit to rebuild my carbs. I've started with carb #1 and have the whole thing torn down except...
Measuring calipers, I assume that's the way to measure shims? I've gone through the brake calipers, put new seals and such in but left the brake...
Yeah I've had a vacuum leak as long as I've had the bike but this spring when I took it out of the garage and washed it the cracks got...
I usually buy parts from Chacal but I'm very poor at the moment so I need the most affordable options possible while still doing a proper job, any...
PO said he did the brakes but I've never believed him, when I hit the break pedal the break light comes on and goes off before I the break ever...
Can these rotors be turned? I looked at the gouge, it isn't quite as deep as I thought it was, more of a scrape but it definitely doesn't look...
Oh and I'm pretty sure I greased the pivot pin when I went through the calipers, I used a guide from the site here and didn't miss any steps...
I used a straight edge and the rotor was definitely bent. Yesterday I found a rotor here in town for $20 that had some light superficial looking...
Oh and If I were to buy another seat to make this swapable would any model XJ750 bolt right in to the hinges for the 82 Seca XJ50, or for that...
I'm rather tall and feel a little cramped on my xj750, how far back can I move the seat and still handle the bike well? Is positioning your body...
Hello, I have an 82' Seca XJ750 A couple of years ago I put in a new fork seal kit and while I had the tire off I redid the break calipers and...