I'm in bc
Was it a pretty straightforward swap? I see they ask about your exhaust but it doesnt seem to ask about elevation.
Seen an Instagram post from murraycarbs saying they have xj carbs. Was wondering if anyone has a set on and how they like them if so.
Does anyone know how the Murray carbs are? Just seen an Instagram add saying they have xj carbs. Wondering if anybody is running them
You got it K-moe. I said before the parts don't even have some wires connected. It was more of a don't bye crap post
I'm assuming the po fried the original one and did the same thing I did, order shitty ones from China off Amazon. New windings are around the...
When I bought the bike it came with one on it and one in a box. Both did nothing for charging the battery. Asked yamaha how much they said 200...
So perfectly level side to side and front to back? Pods look like cheep ones And 3 out of 4 have a make shift velocity stack kinda thing. I'll...
The slides were drilled, I checked with the bit inside the dyno kit. I didn't get the airbox with the bike, it already had the pods. Shims are...
[ATTACH] Should this hole just above the 195 jet have a brass plug in it? It goes to the "choke" plunger and down to the brass tube in the float...
[ATTACH] Should this hole just above the 195 jet have a brass plug in it? It goes to the "choke" plunger and down to the brass tube in the float bowl
xj750 1982 Yea I haven't ran it since I put the 136 into it. The dyno jet kit said to install them, I'm thinking I'll be down sizing that once I...
Have then Haynes manual and read on here that it's wrong, just checking. Hitachi hsc32 Po put a stage 3 dyno jet kit in 4 to 1 exhaust and...
I think I'll do round #2 for carb clean. Round 1 was all about the float bowls. Maybe I'll knock out those passages just to make sure. If I do...
I can only adjust the butterfly to cover or not to cover the 2 unknown holes. Nothing I can do to cover the mixture screw, it's to far away from...
So all 3 get covered Do you know what the other 2 are?
That hole is directly under the mixture screw.... Unless it's not the mixture screw.... The head of the screw is beside the choke/inrichment...
Can you guys help me out. Trying to get it to idle ok so I can sync. Was wondering were to bench set the butterfly In relation to these holes. I...
Just got the bike and I'm going through everything and found the fuel height was way to high. Fuel was coming out of the air compensators half way...
Using 94 from chevron. Had it every where last night from setting the floats
Is this thing on...
New to me 1982 xj750 and new to this site. Anybody around anymore?