1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

Search Results

Search Again
  1. luminaman
    Thread

    82 Maxim XJ750 Master Cylinder Rebuild Kit

    Need help. I'm rebuilding the master cylinder, but ALL the aftermarket rebuild kits available online are WRONG! The diagram in the Haynes manual...
    Thread by: luminaman, May 26, 2011, 2 replies, in forum: XJ Technical Chat
  2. luminaman
    Post

    Mystery Master Cylinder

    Re: Mystery Master Cylinder 7A7 On closer examination, I found the number 7A7 stamped into the cylinder. The number is located just to the left...
    Post by: luminaman, May 26, 2011 in forum: XJ Technical Chat
  3. luminaman
    Post

    Mystery Master Cylinder

    Can't seem to get this picture attached. http://photobucket.com/luminaman
    Post by: luminaman, May 26, 2011 in forum: XJ Technical Chat
  4. luminaman
    Post

    Mystery Master Cylinder

    Here's the link to the pic of my master cylinder. I ordered a rebuild kit, but the piston was too long. Ironically, it matched the one I removed....
    Post by: luminaman, May 25, 2011 in forum: XJ Technical Chat
  5. luminaman
    Post

    Mystery Master Cylinder

    It's an 82 Maxim XJ 750. I cannot seem to attach a photo. I will gladly send to your personal email if you're willing.
    Post by: luminaman, May 25, 2011 in forum: XJ Technical Chat
  6. luminaman
    Thread

    Mystery Master Cylinder

    I have an 82 XJ 750. Unfortunately, I don't think the master cylinder on it is for this bike. The markings on the unit are 5/8 6 V I (or 1). Does...
    Thread by: luminaman, May 25, 2011, 10 replies, in forum: XJ Technical Chat
  7. luminaman
    Post

    Give Me A Brake!

    When you say to only open the bleeder screw a little: do I pump up the pressure in the master cylinder, hold the handle "in", and then open & close?
    Post by: luminaman, May 25, 2011 in forum: XJ Technical Chat
  8. luminaman
    Thread

    Give Me A Brake!

    I'm about to throw in the towel. All I want is a front brake system that works. So, I removed the calipers, cleaned the pistons, installed new...
    Thread by: luminaman, May 25, 2011, 5 replies, in forum: XJ Technical Chat
  9. luminaman
    Post

    Master Cylinder Spring Clip

    HELP! I've installed the new piston, gasket and rubber cap. The piston moves freely, but no brake fluid comes out the hose end. Have I installed...
    Post by: luminaman, May 23, 2011 in forum: XJ Technical Chat
  10. luminaman
    Thread

    Master Cylinder Spring Clip

    I'm trying to remove the spring clip that secures the master cylinder piston in my 82 XJ 750. Dumb question: am I trying to contract the clip or...
    Thread by: luminaman, May 23, 2011, 3 replies, in forum: XJ Technical Chat
  11. luminaman
    Thread

    Spongy Brakes

    I just replaced the piston seals and brake pads on my 82 Maxim XJ 750. I have repeatedly bled the lines, and no air bubbles appear. When I do a...
    Thread by: luminaman, May 20, 2011, 4 replies, in forum: XJ Technical Chat
  12. luminaman
    Post

    82 Maxin 750 XJ Engine Racing

    Re: 82 Maxin 750 XJ "Floating" Idle I think the plugs look normal. I'd like to do a vacuum reading. Somewhere I saw a post about building your...
    Post by: luminaman, May 9, 2011 in forum: XJ Technical Chat
  13. luminaman
    Post

    82 Maxin 750 XJ Engine Racing

    Bill, I'm sorry to be a dope, but what are the slide bores? Are they the chambers that the throttle valves are in?
    Post by: luminaman, May 7, 2011 in forum: XJ Technical Chat
  14. luminaman
    Post

    82 Maxin 750 XJ Engine Racing

    Let me start by thanking all who have responded with advice: it is great! If you'll allow, another post/update. After putting in a new battery and...
    Post by: luminaman, May 7, 2011 in forum: XJ Technical Chat
  15. luminaman
    Post

    82 Maxin 750 XJ Engine Racing

    When you say "air leaks," do you mean something as simple as a hole in one of the rubber "boots"?
    Post by: luminaman, May 5, 2011 in forum: XJ Technical Chat
  16. luminaman
    Post

    82 Maxin 750 XJ Engine Racing

    When I had the carbs out I actually did "sync" them in the manner you suggested, and the were all good to go. If you can tell me how to construct...
    Post by: luminaman, May 5, 2011 in forum: XJ Technical Chat
  17. luminaman
    Post

    82 Maxin 750 XJ Engine Racing

    I did not sync the carbs: I don't have the equipment or experience. Both the throttle and choke (which I'm not using) operate smoothly, and the...
    Post by: luminaman, May 5, 2011 in forum: XJ Technical Chat
  18. luminaman
    Thread

    82 Maxin 750 XJ Engine Racing

    I recently removed, cleaned, and reinstalled the carburetors. The engine now runs smoothly BUT when I apply some throttle, the engine revs WAY WAY...
    Thread by: luminaman, May 5, 2011, 17 replies, in forum: XJ Technical Chat
  19. luminaman
    Post

    No Spark

    Yes, I checked the fuses. The coil is next. I've been putting off getting a multimeter. Sounds like it's time!
    Post by: luminaman, Jun 2, 2009 in forum: XJ Technical Chat
  20. luminaman
    Post

    No Spark

    First I made sure the battery had a full charge. Then I pulled plug four and turned the engine over. No spark.
    Post by: luminaman, Jun 2, 2009 in forum: XJ Technical Chat
  21. luminaman
    Thread

    No Spark

    My '82 750 Maxim will turn over, but I'm not getting a spark at the plug. Is it the plugs? Wires? Coil?
    Thread by: luminaman, Jun 2, 2009, 8 replies, in forum: XJ Technical Chat
  22. luminaman
    Post

    No Spark

    I checked the fuses first, and all appear okay. I also checked the stop/run switch.
    Post by: luminaman, Aug 10, 2008 in forum: XJ Technical Chat
  23. luminaman
    Thread

    No Spark

    My '82 750J Maxim has been running well. All of a sudden it won't start. The cylinders are getting fuel, but there's no spark. It is a coil issue?
    Thread by: luminaman, Aug 10, 2008, 5 replies, in forum: XJ Technical Chat
  24. luminaman
    Thread

    Exhaust Pipe Leak Repair

    Anybody know anything about epoxys that can be used to repair small leaks in my exhaust pipes? I've heard there are puttys that work. True?
    Thread by: luminaman, Jul 23, 2008, 2 replies, in forum: XJ Technical Chat
  25. luminaman
    Thread

    Wanted: '82 750 Maxim Battery Level Sensor

    I'd sure love to find one of these.
    Thread by: luminaman, Jul 21, 2008, 1 replies, in forum: For Sale, Trade/Swap, Wanted
  26. luminaman
    Post

    '82 750 Maxim Battery Sensor

    Forgive my confusion. Do I; (1) insert resistor into a length of wire (2) attached one end of wire to positive terminal of battery (3) attach...
    Post by: luminaman, Jul 19, 2008 in forum: XJ Technical Chat
  27. luminaman
    Thread

    '82 750 Maxim Battery Sensor

    :?: My '82 750 Maxim is missing its battery sensor, so the red warning light on the console flashes continually. I've heard I can "fool" the...
    Thread by: luminaman, Jul 19, 2008, 5 replies, in forum: XJ Technical Chat
  28. luminaman
    Thread

    Side Reflectors for '82 750 Maxim?

    Looking for a pair. :!:
    Thread by: luminaman, Jul 17, 2008, 1 replies, in forum: For Sale, Trade/Swap, Wanted
  29. luminaman
    Thread

    Sea Foam

    Anybody ever tried using Sea Foam in their gas or crankcase? I've heard good things about it. :?:
    Thread by: luminaman, Jul 17, 2008, 12 replies, in forum: XJ Technical Chat
  30. luminaman
    Thread

    WANTED: 1982 750J Maxim Owner's Manual

    I'm looking for a new or used manual. jka928@yahoo.com
    Thread by: luminaman, Jul 16, 2008, 2 replies, in forum: For Sale, Trade/Swap, Wanted
  31. luminaman
    Post

    Oil Capacity For '82 750 Maxim

    Right now it's in the middle when the bike's running. Should it be up on the stand when I'm checking it?
    Post by: luminaman, Jul 16, 2008 in forum: XJ Technical Chat
  32. luminaman
    Thread

    Oil Capacity For '82 750 Maxim

    I just purchased a used '82 750 and don't have a manual yet. I want to change the oil ASAP. Can someone tell me the correct capacity?
    Thread by: luminaman, Jul 16, 2008, 22 replies, in forum: XJ Technical Chat
Showing results 1 to 32 of 32
Search Again