1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

Blipping - Myhtbusters required?

Discussion in 'Hangout Lounge' started by redcentre003, Apr 28, 2008.

  1. redcentre003

    redcentre003 Member

    Messages:
    239
    Likes Received:
    0
    Trophy Points:
    16
    Location:
    Australia
    This topic was the subject of debate at a recent caffeine stop during a ride.

    Does blipping the throttle immediately before switching off the engine draw extra fuel into the carbs in readiness for the next startup...especially if the bike has been resting for a while?
     
  2. RickCoMatic

    RickCoMatic Well-Known Member

    Messages:
    13,843
    Likes Received:
    66
    Trophy Points:
    48
    Location:
    Massachusetts, Billerica
    Insignificantly, on bikes that have Diaphragms and Slides.

    No. On Fuel Injected Bikes.

    It's like an Urban Legend.
    Back when there wasn't Electric Start you wouldn't do it because you'd wet the spark plugs and it would make kicking it over tough after letting the bike get dead cold.

    Same held true for Kicking it over without the Ignition ON. There were those that believed it made it easier to start the bike.
    Other were leery about kicking it without the Ignition on in fear of flooding.

    Makes for a good debate!
     
  3. Robert

    Robert Active Member

    Messages:
    7,479
    Likes Received:
    9
    Trophy Points:
    38
    Location:
    Ventura CA
    Another point to ponder is the introduction of a fuel rich charge into the cylinder where it would sit and condense. What happens when you have raw fuel run down the side of your cylinder wall? The oil layer is washed away, leaving an unprotected wall just waiting to feel the sharp edge of a ring. In short order, you wear out holes.
     

Share This Page