1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

Engine pre-oiling

Discussion in 'XJ Technical Chat' started by sgary, Nov 30, 2008.

  1. sgary

    sgary Member

    Messages:
    145
    Likes Received:
    0
    Trophy Points:
    16
    Location:
    Burnaby, BC, Canada
    I'm re-assembling my 550 today. I'm using assembly lube and am going to spin the crank to pre- lube the engine. Is there an easy way to do this?
    Anything my Clymer manual doesn't cover or is wrong?
     
    sgary, Nov 30, 2008
    #1
  2. TIMEtoRIDE

    TIMEtoRIDE Active Member

    Messages:
    4,686
    Likes Received:
    11
    Trophy Points:
    38
    Location:
    Clermont FL near Orlando
    Pre-oiling can be done by winding the motor over with plugs out and ignition off or disconnected in 15 second bursts (to avoid starter heat) with a battery boost or jump from non-running car.

    I would guess 30 seconds should completely oil a dry XJ motor.
    To check, you would have to see oil at the cams, or use a gauge.
     
    TIMEtoRIDE, Nov 30, 2008
    #2

Share This Page