Starter Clutch Fix - The Method

Below is a post from Bike-Man-Man who like me has performed open heart surgery to replace starter clutch springs and rollers. There's been a couple of posts on this lately so it maty be useful to those in need:

"Yes, it is possible, however if you drop the rollers, springs, or spring caps in the crankcase, you going to have to do it the "right" way anyway...Be prepared....The keys are some patience and go slow...

I'm doing this from memory so if I left something out or you have a question, please let me know....

First I took off the starter assembly off and the alternator cover and positioned it aside...Next you must remove the stator (the big copper thing inside the cover that spins w/the engine) there's a bolt in the middle to remove, but the stator has to be pressed off the shaft, you'll have to have a special tool...I've seen them on ebay, but I modified an old harmonic balancer removal tool (the threads were the same)...If you look at the stator it has threads cast into its housing, thread the special puller bolt into that, and while turning the puller, the stator will slide off the shaft....Next, remove the three torx screws that hold the retainer plate to the case....Then, the oil spray tube can be removed...Now the tricky part, pull the shaft out of the case (the starter clutch unit will fall down) using long screw drivers separate the two halfs of the clutch mechanism....The half closest to you will have the chain wrapped around it, and half farthest from you will contain the rollers, springs, and spring caps....Using the long screwdriver, hold the farther section up higher than closer, using another screwdriver you can manipulate, and rotate the clutch/roller mechanism around to remove the three rollers, springs, and caps....A telescoping magnet will help alot...Reassemble the opposite of removal, go slow, make sure both halves of the clutch mate together properly, use a dab of grease to hold the springs, and caps together....

I will also add as a side note, as it may or may not be required to do so, but I did have the trans clutch removed while doing this, and I also unbolted the idler gear that goes between the starter and the starter clutch(this is done from the trans clutch side)....The idler gear will fall down an inch but can easily be manipulated with magnets and screwdrivers...

I think that's it....I will say, that not doing this the "right" way saved a TON of time, but it is risky, and could cause engine damage if not done correctly...I had nothing to lose, the springs cost $2 a piece, and I got the bike for $100....It now starts and runs good, although I haven't gotten to ride it yet.."

 

Dear Mr. Centre, could you do it all again, while taking pictures, please.