I'm not sure if there is a reason you're jumping right to the coil... I'd start by pulling the plugs on 1 & 4. Are they wet? With the plug...
ok, I'll be happy with 42! I do tend to get into it a bit...
I'm sure this has been asked a thousand times. So that would make this one thousand and one! Rode the bike to work today. Put about 50 miles on...
that's normal. The floats will shut the fuel off once the bowls are full.
There are no short cuts! Take your time and read, and then re-read, everything these guys say to do. My bike is finally running after several...
Just got back from a 15 mile ride. Not only does it rev, but it flies!
Been at it three hours this morning. Pulled the carbs, checked the floats - they were off. again. Ran out & bought myself a decent set of...
JB Weld might do the trick on that. just be sure to clean it first! I "fixed" a hole in my daughter's catalytic converter on her Ford taurus. It...
I feel like I've been struck stupid! These carbs are killing me. In a previous post just over a week ago, it was suggested that I re-do the bench...
oh - and welcome to the site! There are ALOT of very helpful people here that really know these bikes. For parts that you can't find in a...
I have NGK D8EA in my '82 550. Seems to work nicely, and they're readily available at most parts stores.
Thanks everyone. I'll start with buying new caps and vacuum line after work tomorrow. I'm almost positive I did the bench sync correctly....
