Hello! I bought a XJ600 last week that wasn't running, just got her running tonight and took her for a quick run. Noticed that I lost power at...
Hi guys I started fixing an old 1984 XJ600 (51J), have completely clean and re-built the carburetor however whatever I tried it just won't idle....
Bought the bike non-running. Had a stripped starter idler gear, split the case replaced all that and threw it back together and it started right...
I picked up a partially disassembled '93 Seca II for just $100 bucks a while ago and am struggling to get it to start. Now that I've replaced all...
Just trying to figure out the torque for the front axle on my 1985 FJ 600. haynes manual has abdicated responsibility in providing this...
Hey Everyone, This is my first post. I bought a 1992 Seca ii today and had a great time riding it. Parked it and turned it off. then when i went...
Hello I have a 1993 Yamaha Seca II 600 for sale. It has 3390 original miles. The bike runs and looks great. The right hand exhaust pipe has 3...
Hi folks, I'm new to the forum but have been reading and searching through old posts to try and inform myself on this model - I recently...
Hello im Robin from the Netherlands and im new here. I did a conversion of my diversion into a naked, everything is running smoothly just waiting...
Unfortunately, I have 3 broken center cam caps on my 86 yamaha yx600. What is the standard procedure for this? Can i try to replace them from a...
Hi, Does anyone have any suggestions for a rear suspension upgrade for the xj600? The xj600 is essentially the european version of the FJ600 and...
Does anyone have a good wiring diagram for a 85 fj/xj 600? As far as i know the the only difference between the 2 bikes mechanically is the...
Looking for people with a similar bike. I'm new to bikes in general and recently bought my first one. Maybe we can get a dialogue going so when I...
Hello all, my name is Kyle Schroeder and I'm just getting back into riding after about 3 years. Currently working on a z1000 that just needs some...
Hi, Does anyone have a good clear scan from the Haynes manual a wiring diagram for the 1984 xj/fj600? I found a scan of it but I can't make heads...
Hello Bikers I have a Xj600 51J 1986, is there anybody who knows, if you can make a 100 % swingarm and Shock swap. without to make changes to the...
I'm looking at buying my second XJ to have some fun this summer while I'm working in Norway. I wanted to ask what to look for on these bikes. Are...
Ok so i have all per diversion; An xj600 engine and carbs 2 frames 1 is newly painted with few scuffs 2 sets of forks 1 already attached to...
Hello there, This is my project that is about to get finished. It's based to 1990 XJ600 that I bought in a good condition. Things I did include:...
Hello forum users, I've been following this forum for some time now while rebuilding and modyfying my XJ600 and I have finally decided to come...
I have a wire harness, with fuse box, 2 coils, and an ecu from a previous bike i owned for sale. Best reasonable offer + shipping. thanks
1989 Yamaha XJ600 (pre-Diversion). I've owned it for over 20 years and run it as an occasional summer bike. It was a reliable runner before being...