1. Some members were not receiving emails sent from XJbikes.com. For example: "Forgot your password?" function to reset your password would not send email to some members. I believe this has been resolved now. Please use "Contact Us" form (see page footer link) if you still have email issues. SnoSheriff

    Hello Guest. You have limited privileges and you can't "SEARCH" the forums. Please "Log In" or "Sign Up" for additional functionality. Click HERE to proceed.

Engine Paint

Discussion in 'XJ Technical Chat' started by Screaming650, Aug 12, 2009.

  1. Screaming650

    Screaming650 Member

    Messages:
    55
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    Washington Court House, Ohio
    Im thinking of painting my XJ 650 Yics motor on my bike. It has a few places that could use some attention so Im going to paint the block(was thinking light grey/gunmetal) Ive already painted the jug with High temp black(1200 degree) Is there a paint thats recomended that wont chip or flake in the next few years after I apply the paint? Or maybe a nice proceedure from someone that has already accomplished this?
     
    Screaming650, Aug 12, 2009
    #1
  2. bigfitz52

    bigfitz52 Well-Known Member Premium Member

    Messages:
    21,283
    Likes Received:
    419
    Trophy Points:
    83
    Location:
    Rural SE Michigan 60 miles N of Motown
    I've had good luck with Duplicolor's 500* engine enamels; once fully cured (takes about a week) it's tough as nails. I've only used it on valve covers though, and to repaint the black part of my wheels.

    The UPPER half of your crankcase was painted silver from the factory; the lower is "raw."
     
    bigfitz52, Aug 12, 2009
    #2
  3. Polock

    Polock Well-Known Member

    Messages:
    9,751
    Likes Received:
    2,097
    Trophy Points:
    113
    Location:
    Beaver Falls, PA
    Polock, Aug 12, 2009
    #3

Share This Page